Deep Blue BlueFox Basic Instrucciones de operaciones descargar pdf (Pagina 27)

6.2 Entering the PIN

A PIN (Personal Identication Number) can be set to prevent operating modes from

unintentional change. See Changing the PIN, page 25.

Select the desired operating mode by pressing the

corresponding button.

If a PIN has been set to prevent operating modes

from being unintentionally changed, the LED to the

left of the depressed button will start to ash and

the 4 yellow LEDs above the keypad will prompt

you (by ashing) to enter the 4-gure PIN.

Enter the 4-gure PIN.

Forgotten the PIN?: See Changing the PIN, page 25

When each character is entered, one of the 4 yel-

low LEDs will change from ashing to permanently

illuminated.

To delete the entered characters press the C but-

ton.

Conrm the entry with OK.

The LED to the left of the selected operating mode

will then be permanently Illuminated. When passive

mode is activated the LED will continue to ash

until the waves have subsided.

If an incorrect PIN is entered the system will return

to the operating mode that was active before the

PIN was entered.

Cancelling the change of operating mode: By click-

ing the button / button or after 10 seconds

when no button has been pressed, the system will

return to the previously active operating mode.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Sin comentarios

Deep Blue BlueFox Basic Instrucciones de operaciones Pagina 27