Deep Blue BlueFox Basic Instrucciones de operaciones descargar pdf (Pagina 22)

6 System settings

Warning!

When the “System settings” operating mode is activated, the BlueFox

system does not monitor the pool and cannot trigger an alarm. Only

activate the “System settings” operating mode when the pool is being

monitored by another person.

Proceed as follows to carry out system tests or to change system settings:

1. Activate system settings

Press the button.

If PIN protected: Enter the 4-gure PIN and then press OK (see page 27).

Following successful activation the LED alongside the button will

illuminate permanently.

2. Find the desired function in the table below (system test or system settings)

and then enter the corresponding number combination. When each character

is entered, one of the 4 yellow LEDs will illuminate. To delete the entered char-

acters press the C button.

3. Conrm entry of the number combination with OK.

At this point you will have the following options:

y Repeat points 2 and 3 to carry out further system settings.

y Press the button to quit "System settings". BlueFox will return to the previous

operating mode (e.g. “Active mode”).

Timeout: If no buttons are pressed for 10 seconds, the system will return to the

previous operating mode.

6.1 System tests and system settings

In the following table you will nd a list of the possible system tests and all of the

system settings that can be change by the user.

Preparation:

If "System settings" has not yet been activated, then do so (see Activate system set-

tings, page 22.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Sin comentarios

Deep Blue BlueFox Basic Instrucciones de operaciones Pagina 22